Flaps

Seeking advice. I want to position and drill FL-303R to the skins.

1. Can I trust the plans dimensions that form the angle off of FL-302?

2. Trimming the top and bottom inboard flap skins looks tricky. Any tips on how and when to do this?

3. I plan on using the RV-8 flap fairings as suggested by Randy.

I found the nice pics needed on Randy's RV-8 site. Perfect. It looks like a whole lot of trim and fit happening after mating the wing and positioning the flap fairing. Voices of experience would be good to hear from. Thanks in advance.

IMHO
You can go ahead and drill the top skin, I wouldn't trim the skins untill final fit with fuselage. I've seen many variances on the bottom skin to fuselage overlap with no two being the same. The 3 kit is the classic slow build kit and not many of the parts fit without tweeking.
Tom
Builder/pilot/bill payer
RV3 976TM
RV3 978TM