What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

TruTrack Autopilot CWS

tangocharlie123

Active Member
How do you test that the control wheel switch is working while doing ground testing, apart from checking the continuity of the wires.
Thanks
 
How do you test that the control wheel switch is working while doing ground testing, apart from checking the continuity of the wires.
Thanks

If you push the switch and it works for enable/disable (connect/disconnect), then you're good to go - as it's the same switch!

Cheers,
Stein
 
Engage the autopilot on the ground. It will start ticking in one direction looking for a reaction. As it does push the CWS button and you should feel the resistance go away.
 
Thanks for the advice
went and cut the old switch which was faulty out found an earth point and bridged the wire and it works

Have ordered new Control Grips today as well.
Peter
 
Back
Top