Has anyone used or purchased ATS springback dimple dies or other tools? I'm curious about the quality compared to Avery and Cleveland products. The ATS dies are about $10 less than most other parts suppliers, which is a substantial savings. I plan on getting 1/8, 3/32, #6 and #8. Thanks
Van's Air Force
Don't miss anything! Register now for full access to the definitive RV support community.
Springback Dimple Dies quality
- Thread starter Rockyjs
- Start date
ATS dies
I have a set of 3/32 ATS spring back dies. They work fine.
I did a comparison in front of Clevelands folks up at the Copperstate fly-in 4 yrs ago with the ATS and Cleveland dies. Cleveland couldn't tell the difference between the end results.
That was 4 yrs ago.
Both Avery and Cleveland make great tools. I have a few Avery dies and they work great.
Your mileage may vary.
Paul
I have a set of 3/32 ATS spring back dies. They work fine.
I did a comparison in front of Clevelands folks up at the Copperstate fly-in 4 yrs ago with the ATS and Cleveland dies. Cleveland couldn't tell the difference between the end results.
That was 4 yrs ago.
Both Avery and Cleveland make great tools. I have a few Avery dies and they work great.
Your mileage may vary.
Paul
